Questions & Answers

I installed a heat mat in a small bathroom. Per the instructions totally enclosed heat wires in thinset. However there is a splice where the ac power meets the heat wire inside the mat itself. During the dry fit of the tiles I see its going to cause a signifigant bump in the floor and cause the tile on top of it to be really off and higher than the tiles around it. I wish I would have noticed this prior to installing the thinset but I didn't. Now I'm wanting to know what my options are. Should I just build up all the other tiles around to get it level, or possiby is there a way to remove material from the back of the tile to help it sit more even with the others. Not sure what to do, just looking for suggestions.