Schluter trim has ever so slight bow to it...
58" Quaddec trim is slightly bowed. I figured this out when I was lining up the edge of the trim to the tile below the niche to determine where on the sill to park it. The trim is flexible, and it bends in the right direction, meaning if I set it, I can push on the center and it will flatten out. However, I'm wondering what I could use to put pressure on it while the thinset cures as It would probably work its way out from under the sill tile if left alone.
Thoughts?
22 Views
Ooh ooh...I figured it out.
At the top of wall, I added leveling clips. Fortunately, I'm using the Spin Doctor system. With the stems of the clips below the trim, I can use the red spinner to crank the trim into place.
To hold the ends of the trim in place, I tacked the trim in position on the very ends.
We'll see how it goes tomorrow after the work I've done today cures.